Appendix F: flash information

Что это за flash information? Далее следует вот что (с этим помогать не нужно):

• USE b99.15 TO SAVE PARAMETERS
• USE b99.14 TO SAVE PLC PROGRAM
• TO CHANGE PLC INSTRUCTIONS b99.13 MUST BE AT 0
• WHEN CHANGING OPERATING MODE USE b99.11 TO LOAD DEFAULT PARAMETERS (b40.2=0)
• WARNING, BEFORE CHANGING Pr31 MAKE SURE b40.2=0
• SPEED REFERENCE IS LIMITED TO THE VALUE IN Pr32
• IN TORQUE CONTROL Pr2 AND Pr3 MUST BE SET TO 1000
• TO USE THE ACTIVE OPERATING MODE b40.2 MUST BE SET TO 1
• TO USE Pr32 TO CHANGE FEEDBACK RESOLUTION ON THE FLY, DISABLE TORQUE COMPENSATION (b42.6=0)
• IF YOU CANNOT UPDATE READ/WRITE PARAMETERS FROM THE KEYPAD, MAKE SURE b99.7=0. IF b99.7=0, THE PARAMETERS ARE PROBABLY MANAGED BY THE PLC PROGRAM.